针对深水固井候凝期间水泥浆温度、压力与水化反应之间复杂的相互作用,基于水泥浆水化反应动力学建立深水固井候凝井筒温度压力耦合模型,利用差分法进行耦合数值求解,并将计算结果与实验及现场数据进行对比以验证模型的准确性。考虑水化反应、温度、压力之间的相互作用时,新建立的固井井筒温度压力耦合模型计算精度在5.6%以内,能够很好地满足工程要求。结合深水井开展数值模拟分析候凝期间井筒温度、压力、水化度的演化规律,研究结果表明：水泥浆温度在水化热作用下会迅速升高;随着水泥浆胶凝强度的发展,水泥浆的孔隙压力会逐渐降低,甚至低于地层压力,从而引发气窜;瞬态变化的温度和压力会影响水泥浆水化反应速率,井筒深部的水泥浆在高温高压环境下具有更快的水化反应速率;对于深水固井作业来说,泥线附近的低温环境会延长水泥浆的候凝时间,导致固井工作周期变长。图16表2参26
Considering the complicated interactions between temperature, pressure and hydration reaction of cement, a coupled model of temperature and pressure based on hydration kinetics during deep-water well cementing was established. The differential method was used to do the coupled numerical calculation, and the calculation results were compared with experimental and field data to verify the accuracy of the model. When the interactions between temperature, pressure and hydration reaction are considered, the calculation accuracy of the model proposed is within 5.6%, which can meet the engineering requirements. A series of numerical simulation was conducted to find out the variation pattern of temperature, pressure and hydration degree during the cement curing. The research results show that cement temperature increases dramatically as a result of the heat of cement hydration. With the development of cement gel strength, the pore pressure of cement slurry decreases gradually to even lower than the formation pressure, causing gas channeling; the transient temperature and pressure have an impact on the rate of cement hydration reaction, so cement slurry in the deeper part of wellbore has a higher rate of hydration rate as a result of the high temperature and pressure. For well cementing in deep water regions, the low temperature around seabed would slow the rate of cement hydration and thus prolong the cementing cycle.
[1] 高永海, 刘凯, 赵欣欣, 等. 深水油井测试工况下井筒结蜡区域预测方法[J]. 石油勘探与开发, 2018, 45(2): 333-338.
GAO Yonghai, LIU Kai, ZHAO Xinxin, et al.Prediction of wax precipitation region in wellbore during deep water oil well testing[J]. Petroleum Exploration and Development, 2018, 45(2): 333-338.
[2] PANG X, JIMENEZ W C, IVERSON B J.Hydration kinetics modeling of the effect of curing temperature and pressure on the heat evolution of oil well cement[J]. Cement & Concrete Research, 2013, 54: 69-76.
[3] LIN F, MEYER C.Hydration kinetics modeling of Portland cement considering the effects of curing temperature and applied pressure[J]. Cement & Concrete Research, 2009, 39(4): 255-265.
[4] SHENG G, SU Y, WANG W.A new fractal approach for describing induced-fracture porosity/permeability/compressibility in stimulated unconventional reservoirs[J]. Journal of Petroleum Science and Engineering, 2019, 179: 855-866.
[5] VELAYATI A, ROOSTAEI M, RASOOLIMANESH R, 等. 胶质气体泡沫基泡沫水泥体系[J]. 石油勘探与开发, 2019, 46(6): 1206-1211.
VELAYATI A, ROOSTAEI M, RASOOLIMANESH R, et al.Colloidal gas aphron (CGA) based foam cement system[J]. Petroleum Exploration and Development, 2019, 46(6): 1206-1211.
[6] COOKE C E, KLUCK M P, MEDRANO R.Field measurements of annular pressure and temperature during primary cementing[R]. SPE 11206, 1983.
[7] 尹成, 何世明, 徐壁华, 等. 对常规注水泥温度场预测方法的评价[J]. 西南石油大学学报, 1999, 21(4): 57-60.
YIN Cheng, HE Shiming, XU Bihua, et al.Evaluation of conventional prediction method of temperature field during well cementing[J]. Journal of Southwest Petroleum Institute, 1999, 21(4): 57-60.
[8] WEDELICH H, GOODMAN M A, GALATE J W.Key factors that affect cementing temperatures[R]. SPE 16133, 1987.
[9] DAVIES S N, GUNNINGHAM M M, BITTLESTON S H, et al.Field studies of circulating temperatures under cementing conditions[J]. SPE Drilling & Completion, 1994, 9(1): 12-16.
[10] BITTLESTON S H.A two-dimensional simulator to predict circulating temperatures during cementing operations[R]. SPE 20448, 1990.
[11] GUILLOT F, BOISNAULT J M, HUJEUX J C.A cementing temperature simulator to improve field practice[R]. SPE 25696, 1993.
[12] 刘洋, 艾正青, 李早元, 等. 注水泥循环温度影响因素探讨[J]. 西南石油大学学报(自然科学版), 2012, 34(1): 154-158.
LIU Yang, AI Zhengqing, LI Zaoyuan, et al.Discussion on influencing factors of cementing circulation temperature[J]. Journal of Southwest Petroleum Institute (Science & Technology Edition), 2012, 34(1): 154-158.
[13] 王清顺, 张群, 徐绍诚, 等. 海洋深水固井温度模拟技术[J]. 石油钻探技术, 2006, 34(4): 67-69.
WANG Qingshun, ZHANG Qun, XU Shaocheng, et al.Temperature prediction technique for deep-water cementing operations[J]. Petroleum Drilling Techniques, 2006, 34(4): 67-69.
[14] CARTER L G, SLAGLE K A.A study of completion practices to minimize gas communication[J]. Journal of Petroleum Technology, 1972, 24(9): 1170-1174.
[15] SABINS F L, TINSLEY J M, SUTTON D L.Transition time of cement slurries between the fluid and set state[R]. SPE 9285, 1982.
[16] WILKINS R P, FREE D.A new approach to the prediction of gas flow after cementing [R]. SPE 18622, 1989.
[17] XU B, YUAN B, GUO J, et al.Novel technology to reduce risk lost circulation and improve cementing quality using managed pressure cementing for narrow safety pressure window wells in Sichuan Basin[J]. Journal of Petroleum Science and Engineering, 2019, 180: 707-715.
[18] SUN B, WANG X, WANG Z, et al.Transient temperature calculation method for deep-water cementing based on hydration kinetics model[J]. Applied Thermal Engineering, 2017, 129: 1426-1434.
[19] WANG X, WANG Z, DENG X, et al.Coupled thermal model of wellbore and permafrost in Arctic regions[J]. Applied Thermal Engineering, 2017, 123: 1291-1299.
[20] DRECQ P, PARCEVAUX P A.A single technique solves gas migration problems across a wide range of conditions[R]. SPE 17629, 1988.
[21] PARCEVAUX P A.Pore size distribution of portland cement slurries at very early stage of hydration (influence of curing temperature and pressure)[J]. Cement and Concrete Research, 1984, 14(3): 419-430.
[22] ERIK B N, DOMINIQUE G.Well cementing[M]. Texas, USA: Schlumberger Drive, 2006.
[23] MOORE P.Drilling practices manual[M]. Tulsa, USA: Petroleum Publishing Co., 1974.
[24] KRSTULOVIĆ R, DABIĆ P.A conceptual model of the cement hydration process[J]. Cement and Concrete Research, 2000, 30(5): 693-698.
[25] DILLENBECK R L, HEINOLD T, ROGERS M J, et al.The effect of cement heat of hydration on the maximum annular temperature of oil and gas wells[J]. SPE Drilling & Completion, 2003, 18(4): 284-292.
[26] 阎培渝, 郑峰. 水泥基材料的水化动力学模型[J]. 硅酸盐学报, 2006, 34(5): 555-559.
YAN Peiyu, ZHENG Feng.Kinetics model for the hydration mechanism of cementitious materials[J]. Journal of the Chinese Ceramic Society, 2006, 34(5): 555-559.
